Flat wire is a 3" by 6" sheet of 0.001" thick brass shim. About the same thickness as aluminum cooking foil., but far stronger and very conductive.
This can be easily cut with scissors into 1/4" wide strips and used glued flat on roadbed or baseboard surfaces to invisibly feed full DC or DCC power to and underneath trackwork, without requiring any baseboard drilling, or working underneath your baseboards. Flat wire can be soldered to itself and to regular wire wherever convenient, or crossed insulated over other flatwire paths by interspersing a layer of equally thin PTFE plumbers tape.
INVISIBLE RAIL FEEDER AND TRACK BUS WIRE:
0.010" dia, 30 ga bare, tinned copper wire can be used to as short lengths of feeder wire to power rails from a nearby bus or flat wire section.. Because it has no insulation, it can be fed invisibly under ballast and in between ties, without requiring any baseboard drilling, or working underneath your baseboards.
We supply 30 ga wire in handy 10ft lenghs and full 4 oz. spools (aprox 700 ft)
0.025" dia, 22 ga bare tinned copper wire can be used to as any length of bus wire to supply DC or DCC power to local areas of flat wire or 30 ga feeder wire. Because it has no insulation, it can be fed invisibly under the ballast along the edge of roadbed, without requiring any baseboard drilling, or working underneath your baseboards.
We supply 22 ga wire in 10ft lenghs and full 4 oz.spools (aprox 100 ft)
ULTRA FINE SOLDER PASTE:
Our Solder Paste is the extremely fine grained product as used in industry for modern surface mount PCB eclectronic components. It is a lead-free formula using water clean up flux, for long and dependable joint lifetimes.
We supply the paste in resealable disposable syringes, containing at least 15 gm (3cc) of paste., which can be used as is, to load the pads of our Frog Assembly Fixture.
Stainless Micro-dispensing Needles for the syringes are available separately, if required for other track or general uses.